Verifying The Configuration; Testing The L3 Authenticated Roaming Feature; Simulated Roam Via Power Down Of Ap - D-Link DWL-3500AP Configuration Manual

behalf of the clients, and an entry for each of the users. In this example, you only add one
user entry to the RADIUS database.
This configuration is applicable to only FreeRadius (
server. The configurations in this section involve the following two files:
• C:\Program Files\FreeRADIUS.net-1.1.1-r0.0.1\etc\radd\client.conf
• C:\Program Files\FreeRADIUS.net-1.1.1-r0.0.1\etc\radd\users
1. Add a client entry for AP1 to the clients.conf file:
client 192.168.101.0/24 {
secret
shortname
}
Note: The secret is the same as the one added to the RADIUS Secret field in the
D-LINK-NET1 Wireless Network Configuration.
Similarly add client entry for AP2.
2. Add the user dlink with password admin to the users file as:
dlink Auth-Type := EAP, User-Password == "admin"
3. Restart the RADIUS server (you must restart it after you make any changes to the
configuration file).
4.5

Verifying the Configuration

8.
On WS2, click Monitoring
Valid AP database on WS2.
9. From a wireless client, connect to AP1 and verify that you can see the SSIDs for the
following:
• Guest Network
• D-LINK NET1
• D-LINK NET2
10. Connect to D-LINK-NET1 from a wireless client to verify that WPA2 authentication
is required.
11. After connecting, check the IP address that the switch DHCP server assigned.
12. Start the Roaming Test.
4.6

Testing the L3 Authenticated Roaming Feature

4.6.1 Simulated Roam via Power Down of AP

The following procedure shows how to perform an L3 Tunnel roaming test.
= secret
= my-ap1
Access Points Failed Access Points and add AP2 to the
http://www.freeradius.net/
) radius