Logs & Traps - D-Link DWL-3500AP Configuration Manual

roam an antenna can be connected to one of the APs after you have already associated
with the other.
3.7 Logs & Traps
The administrator can enable or disable SNMP traps sent from the wireless switch and the trap
destinations. The traps can be enabled or disabled by traversing to Administration
Configuration Global in the WLAN tab. In managed mode the AP doesn't generate any
traps. The list below shows all the possible traps generated on the wireless switch:
Note: All traps are disabled by default.
WS Traps
1. WS Enabled
2. WS Disabled
3. WS Managed AP Database Full
4. WS Managed AP – AP Neighbor List Full
5. WS Managed AP – Client Neighbor List Full
6. WS-AP Failure List Full
7. RF Scan AP List Full
8. Client Association Database Full
9. Client Failure List Full
Peer WS Traps
10. Peer WS Discovered
11. Peer WS Failed
12. Peer WS Unknown Protocol Discovered
AP State Traps
13. WS Managed AP Discovered
14. WS Managed AP Failed
15. WS Managed AP Unknown Protocol Discovered
AP Failure Traps
16. WS-AP Association Failure
17. WS-AP Authentication Failure
Rogue AP Traps
18. RF Scan Rogue AP Detected
RF Scan Traps
19. RF Scan New AP Detected
20. RF Scan New Client Detected
21. RF Scan Ad-Hoc Client Detected.
Client State Traps
22. Client Association Detected
23. Client Disassociation Detected
24. Client Roam Detected
Client Failure Traps
Advanced