Operation Control Function By Remote Control Switch - Mitsubishi SRK208HENF-L User Manual

(4) Operation control function by remote control switch

Remote control switch
S Models SRK 208, 258, 288, 328, 408 models
FAN SPEED button
Each time the button is pushed, the •
indicator is switched over in turn.
TEMPERATURE button
This button sets the room temperature.
SET TIMER button
This button sets the ON timer and OFF
timer times.
TEMPERATURE Indicator
Indicator set temperature.
(Does not indicate temperature when
operation mode is on AUTO)
FAN SPEED Indicator
Indicates set air flow with • lamp.
Unit indication section
TIMER
1-56
CONT
AUTO
HI
MED
LO
ON OFF TIMER
FAN SPEED ON / OFF
TEMP
SET TIMER
• The above illustration shows all controls, but
in practice the relevant parts are shown.
CONT
AUTO
HI
MED
LO
ON OFF TIMER
RUN
SRK208HENF
OPERATION MOOD select button
Each time the button is pushed, the •
indicator is switch over in turn.
Press for starting operation, press again
for stopping.
MODE
This button changes the flap mode.
When pressed, this button changes
the mode in the following order:
AIR FLOW
TIMER
ACL
This button changes the selection of
ON timer/OFF timer operation and
normal operation.
Switch for resetting microcomputer.
OPERATION MODE Indicator
Indicates selected operation with • lamp.
Heat pump:
Cooling only:
AIR FLOW Indicator
Shows selected flap mode.
TIMER Indicator
RUN (HOT KEEP) light (green)
• Illuminates during operation.
•Blinks at air flow stop due to the `HOT
KEEP´. (Heat pump type only)
TIMER light (yellow)
Illuminates during TIMER operation.
ON/OFF button
AIRFLOW button
or
(AUTO) (SWING)
no indication
(SWING STOPPED)
TIMER button
RESET switch
(AUTO) · (Cool) · (Heat) · (Dry)
(AUTO) · (Cool) · (Fan) · (Dry)