Dvd Playback - JVC xv-thm45 Instructions Manual

References
PROBLEM
No sound. The system cord and/or speaker cord is not connected.
There is a short in the speaker cord.
The audio cord is not connected to AUX IN and/or
DIGITAL IN correctly.
An incorrect source has been selected.
Muting is on.
The decode mode is not set correctly.
Sound from one front The speaker cord is not connected correctly.
speaker only.
Left-right balance is not set properly.
No sound from the The speaker setting is incorrect.
center and/or surround
speakers.
Bass sound is heard Appropriate bass level for stereo sound is not selected.
reinforced when
listening in stereo.

DVD Playback

PROBLEM
No picture is displayed The video cord or SCART cable is not connected
on the TV screen. correctly.
The RGB-Y/C selector is not set correctly.
TV input selection is incorrect.
The disc is not playable.
A disc cannot be played. The center unit's and disc's Region Code numbers are
incompatible.
Parental Lock is in use.
A disc cannot be played The disc is loaded with its label and data sides inverted. Load the disc correctly. (A pg. 21)
and "0:00" is displayed
on the display window.
The unplayable disc is loaded.
Video and audio are The disc is scratched or dirty.
distorted.
A VCR is connected between the center unit and the
TV.
With some discs, a picture may be blurred when setting
"PICTURE SOURCE" to "FILM" or "AUTO".
The picture does not fit The monitor type is not set correctly.
the TV screen.
The TV is not set correctly.
No subtitle appears on
the TV screen though
you have selected a
certain language as your
initial subtitle language.
Audio language is
different from the one
you have selected as
your initial audio
language.
POSSIBLE CAUSE
POSSIBLE CAUSE
—
—
SOLUTION
Check the connection. (A pg. 10 – 11)
Reconnect the speaker cord.
Connect the cord correctly. (A pg. 12)
Select the correct source. (A pg. 18)
Press MUTING to cancel muting. (A pg. 18)
Select the proper decode mode. (A pg. 20)
Connect the speaker cord correctly. (A pg. 10)
Adjust the balance properly. (A pg. 51, 56)
Set the speaker setting properly. (A pg. 51, 56)
Set "AUDIO POS" properly. (A pg. 56)
SOLUTION
Connect the cord correctly. (A pg. 8)
Set the selector properly for the video input format of
the connected TV. (A pg. 8)
Select the correct input on the TV.
Use a playable disc. (A pg. 3)
Replace the disc. (A pg. 3)
Enter password to change the Parental Lock level.
(A pg. 53)
Replace the disc. (A pg. 3)
Replace or clean the disc. (A pg. 2)
Connect the center unit and TV directly. (A pg. 8)
Set "PICTURE SOURCE" to "VIDEO (NORMAL)" or
"VIDEO (ACTIVE)". (A pg. 51)
Set "MONITOR TYPE" properly. (A pg. 51)
Set the TV properly.
Some DVDs are programmed to always display no
subtitle initially. If this happens, press SUBTITLE on
the remote control after starting play. (A pg. 41)
Some DVDs are programmed to always use the original
language initially. If this happens, press AUDIO on the
remote control after starting play. (A pg. 41)
58