JVC xv-thm45 Instructions Manual page 20

Getting started
Remote control
mode selector
For TV operations
You can operate your TV using the remote control supplied with
this system.
• Refer also to the instruction manuals supplied with your TV.
7 To set the manufacturer's code
You can operate a JVC TV without setting the remote control
signal.
1
Slide the remote control mode selector
to TV.
2
Press and hold F TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
15
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press 0, then 7.
For a Toshiba TV:Press 2, then 9.
(play button)
Number
buttons
5
Release F TV.
6
Try operating your TV by pressing
F TV.
When your TV turns on or off, you have entered the correct
code.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
NOTE
• Manufacturers' codes are subject to change without notice. If they are
changed, this remote control cannot operate the equipment.
• Set the codes again after replacing the batteries of the remote control.
7 Operation
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
F TV:
TV VOL +/–:
TV/VIDEO:
CHANNEL +/–:
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:
Manufac- Manufactur-
Code
turer er
JVC 01 Nordmende
Akai 02, 05 Okano
Blaupunkt 03 Orion
Daewoo 10, 31, 32 Panasonic
Fenner 04, 31, 32 Philips
Fisher 05 Saba
Grundig 06 Samsung
Hitachi 07, 08 Sanyo
Inno-Hit 09 Schneider
Irradio 02, 05 Sharp
Magnavox 10 Sony
Mitsubishi 11, 33 Telefunken
Miver 03 Thomson
Nokia 12, 34 Toshiba
Turns TV on and off.
Adjusts the volume.
Selects the input mode (either TV or
VIDEO).
Changes the channels.
Alternates between the previously selected
channel and the current channel.
Code
13, 14, 18, 26 – 28
09
15
16, 17
10
13, 14, 18, 26 – 28
10, 19, 32
05
02, 05
20
21 – 25
13, 14, 18, 26 – 28
13, 14, 18,
26 – 28, 30
29