Using The Fresh Water System - Chris-Craft 2014 36 RH Corsair Owner's Manual

Using the Fresh Water System

The water tank fill deck plate may be located in the general vicinity of the fuel fill deck plate.
Always keep the fresh water tank full. A full water tank helps keep the water potable.
To fill the water tank:
1. Ensure the water supply is suitable for drinking. If filling from the dock check with the dock-
master to verify the water is potable.
2. Remove the filler cap and fill the tank until water flows from the vent.
3. Secure the filler cap.-
You will need to start the system whenever the tank is empty and air is in the supply lines. To start or
use the fresh water system:
1. Sanitize the system as previously described.
2. Fill the water tank with potable water.
3. Energize the pressure pump.
a. The boat must have electrical power to energize the pressure pump. This can be the batteries, or
if so equipped, an external power source.
b. Turn on the water pressure switch on the salon circuit breaker panel.
4. Open a hot water faucet to fill the water heater and allow air to escape from the line. Close the
faucet when free of air.
5. Starting with the cold water faucet furthest from the pump, open each faucet until you see a steady
stream of water from each faucet. Close the faucets.
6. Open the faucet furthest from the water heater first then open all other faucets. Run until you see a
steady stream of water from each faucet. Close the faucets.
7. Refill the water tank and turn off the pressure pump.
DO NOT put fuel in the water tank or water in the fuel tank.
Systems
3-27