Systems
Trim Tab Control Switches
There is a trim tab switch for each trim tab. The trim tab switches
(Figure 3-18)
are located on the helm switch
control panel. When pressed, the switch activates the pressure pump that moves the trim tab in the desired
direction.
To correct for a listing condition you must lower the trim tab on the listed (lower) side by pushing the top
half of the rocker switch in a half second burst until the boat is righted.
If the stern of the boat is highly loaded, use both switches to operate both tabs, which lowers the bow
when the boat is on plane.
Figure 3-20. Trim Tab Control Switches
Trim Tab Zinc Plate
Each trim tab contains a sacrificial zinc plate which slows the development of corrosion on the tab. This
plate should be inspected and replaced when necessary.
Zinc anode is supplied by the vendor
Figure 3-21. Trim Tab Zinc Plate
3-22