Compass; Figure 3-38 - Chris-Craft 2014 36 RH Corsair Owner's Manual

Generator
To start the generator from the salon panel:
1. Move the On switch to the up (On) position and hold. The green light illuminates.
2. While holding the On switch in the On position, move the Start/Stop switch to the Start position and hold.
3. When the generator starts the starter disengages.
5. Release the Start/Stop switch. It is spring loaded to the center position.
To stop the generator from either location:
1. Move the Stop switch to the down (Stop) position, and hold momentarily.
2. Release the switch when the generator stops.

Compass

A compass is installed on each boat to aid in navigation. A magnetic compass is often deflected by iron,
magnets, or electrical current from nearby wiring and must adjusted to compensate for these influences.
Only a qualified technician should perform compass adjusting/compensation. Since it is seldom possible
to correct compass deviation to zero, a deviation card is created to indicate the correct heading that must
be utilized when navigating by compass. Keep this card near the helm and refer to it as necessary.
Figure 3-38. Compass
Systems
3-51