Fip-1.N3 During Printing - Dell 2130cn Service Manual

FIP-1.N3 During Printing

Step
Possible causative parts:
HOLDER ASSY SEPARATOR (PL2.1.5)
ROLL ASSY FEED (PL3.2.4)
ROLL ASSY REGI (PL3.2.9)
ROLL REGI METAL (PL3.2.10)
PHD ASSY (PL4.1.21)
FUSER ASSY (PL6.1.1)
TRANSFER ASSY (PL6.1.7)
DRIVE ASSY SUB (PL7.1.1)
DRIVE ASSY MAIN (PL7.1.2)
FAN (PL8.1.1)
FEEDER ASSY DUP (PL11.1.1)
Checking the paper feeding
1 Does the noise arise from the printer when the paper is fed
from the Tray 1?
Checking the paper condition in the Paper Cassette
2
Is the paper dry and recommended paper?
Checking noise when the paper is fed from the Tray 1
3
Does the noise arise from the printer?
Checking the HOLDER ASSY SEPARATOR in the Paper
Cassette for rotation
4 Remove the Paper Cassette from the printer.
Does the SEPARATOR ROLLER rotate smoothly?
Turning it with your finger.
Checking the ROLL ASSY FEED for rotation
Remove the Paper Cassette from the printer.
Enter the [Digital Output] - [DO-0] in [CE Diag] tab of [CE
Diag], and then enter the [Digital Output] - [CASSETTE1
FEED SOLENOID ON(Auto OFF)] in [CE Diag] tab of [CE
5
Diag].
Does the noise arise from this Roller?
NOTE: After checking is completed, turn off
[CASSETTE1 FEED SOLENOID ON(Auto OFF)] check
first, and then turn off [MAIN MOTOR ON] check.
Checking the paper guide sides setting and paper setting of
SSF
6
Were the paper guide sides of SSF correctly set, and was
the paper correctly inserted into SSF?
Checking the paper condition
7
Is the paper dry and recommended paper?
Checking noise when the paper is fed from the SSF
8
Does the noise arise from the printer?
Check
1 - 371
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. Go to step 6.
Replace the paper
with a new dry and
Go to step 4. recommended
one, then go to
step 3.
Go to step 4. End of work.
Replace the
HOLDER ASSY
SEPARATOR.
Go to step 5.
(Refer to Removal
2/ Replacement
52.)
Replace the ROLL
ASSY FEED.
(Refer to Removal Go to step 12.
9/ Replacement
45.)
Reset the paper
guide sides, and
Go to step 7. correctly insert the
paper to SSF, then
go to step 7.
Replace the paper
with a new dry and
Go to step 12. recommended
one, then go to
step 8.
Go to step 12. Go to step 9.
No