Dell 2130cn Service Manual page 387

Step
Checking after reseating the FUSER ASSY
Warning: Start the operation after the FUSER ASSY has
10 cooled down.
Reseat the FUSER ASSY.
Is the image printed correctly?
Checking after reseating the TRANSFER ASSY
11 Reseat the TRANSFER ASSY.
Is the image printed correctly?
Checking the paper feeding tray
12
Is the damaged paper fed from the SSF?
Checking the side guides setting of SSF
13 Reset the side guides.
Is the image printed correctly?
Checking the paper path
14
Are there any foreign substances on the paper path?
15 Is the image printed correctly?
Checking the ROLL ASSY REGI and ROLL REGI METAL
for rotation
Enter the [Digital Output] - [DO-0] in [CE Diag] tab, and then
enter the [Digital Output] - [DO-27] in [CE Diag] tab of [CE
16 Diag].
Does the ROLL ASSY REGI and ROLL REGI METAL
rotate?
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK).
Checking the damaged mode
17
Is the damaged paper fed from the Duplex?
Checking the FEEDER ASSY DUP installtion
18 Reseat the FEEDER ASSY DUP.
Does the error still occur when printing?
Checking the paper path
19
Are there any foreign substances on the paper path?
Checking after reseating the Paper Cassette
20 Reseat the Paper Cassette.
Is the image printed correctly?
Checking the side guides of the Paper Cassette
21 Reset the side guides.
Is the image printed correctly?
Checking after reseating a new paper
22 Reseat a new paper in the Paper Cassette.
Is the image printed correctly?
Checking the paper path
23
Are there any foreign substances on the paper path?
24 Is the image printed correctly?
Check
1 - 361
Chapter 1 Troubleshooting
Remedy
Yes
End of work. Go to step 11.
End of work. Go to step 12.
Go to step 13. Go to step 20.
End of work. Go to step 14.
Remove the
foreign
Go to step 16.
substances, then
go to step 15.
End of work. Go to step 16.
Replace the ROLL
ASSY REGI and/
End of work.
or ROLL REGI
METAL.
Go to step 18. Go to step 20.
Go to step 19. End of work.
Replace the
Remove the FEEDER ASSY
foreign DUP. (Refer to
substances. Removal 57/
Replacement 57.)
End of work. Go to step 21.
End of work. Go to step 22.
End of work. Go to step 23.
Remove the
foreign
Go to step 25.
substances, then
go to step 24.
End of work. Go to step 25.
No