Installing Your New Unit; Basic Connections - JVC DR-M10S Instructions Manual

Jvc dvd video recorder instructions
Hide thumbs Also See for DR-M10S:
Table of Contents

Advertisement

16
EN

Basic Connections

TV aerial
cable
ANTENNA IN
L-1 IN/OUT
ANTENNA OUT
ATTENTION:
Your TV must have a 21-pin AV input connector
(SCART) for the connection to the unit.
Aerial connector
Back of TV
RF cable
(provided)
21-pin SCART connector
21-pin SCART cable
(provided)
Mains power cord
Back of unit
Mains outlet

INSTALLING YOUR NEW UNIT

It's essential that your unit be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
A
Check the contents.
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" on page 114.
B
Install the unit.
Place the unit on a stable, horizontal surface.
C
Connect the unit to a TV.
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN
connector on the rear panel of the unit.
C Connect the ANTENNA OUT connector on the rear
panel of the unit and the TV's aerial connector with
the provided RF cable.
D Connect the L-1 IN/OUT connector on the rear panel
of the unit and the TV's 21-pin SCART connector with
a provided 21-pin SCART cable.
The L-1 IN/OUT connector accepts and delivers either a
composite signal (regular video signal), Y/C signal or RGB
signal.
Select an appropriate option of "L-1 OUTPUT" as follows
(
pg. 82):
When your TV's SCART
connector accepts:
Y/C signal (separated
luminance (brightness) and
chrominance (colour) signals)
RGB signal
Set your TV to the VIDEO (or AV), Y/C, or RGB mode
according to the type of your TV's SCART connector.
For switching the TV's mode, refer to the instruction manual of
your TV.
D
Connect the unit to mains.
Connect the AC plug of the mains power cord into a
mains outlet.
"LOADING" blinks on the front display panel when the AC
plug of the mains power cord is connected into a mains outlet,
and it takes the unit approximately 50 seconds to be turned
on. This is not a malfunction.
After connection is completed, perform "Auto Set Up"
on page 19.
Set "L-1 OUTPUT" to:
"SCART S-VIDEO"
"SCART RGB"

Advertisement

Table of Contents
loading

Table of Contents