Installing Your New Unit; Basic Connection - JVC DR-M100S Instructions Manual

Basic Connection

To [ANTENNA IN]
Back of unit
ANTENNA
IN
VIDEO OUT
Y
P L-1
B
OUT
P
R
To
[ANTENNA
OUT]
To
[COMPONENT
VIDEO OUT
(Y/P
B
Component
video cable
(not supplied)
RF cable
(supplied)
To 75 ohm terminal
It's essential that your unit be properly connected.
ATTENTION:
●
Your TV must have a 21-pin AV input connector (SCART) for
the basic connection to the unit.
●
Connect the AC plug only after all connections to the TV has
been completed.
TV aerial cable
Mains power cord
L-2 COAXIAL
To [L-1 IN/OUT]
21-pin SCART
/P )]
R
cable
(supplied)
TV
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO
OPERATION CAN BE PERFORMED.
1
Place the unit on a stable, horizontal surface.
2
Connect the unit to a TV depending on the TV and cables you
use.
8 Basic Connection
To connect to a TV with 21-pin SCART input connector ^
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the [ANTENNA IN] connector on
the rear panel of the unit.
C Connect the [ANTENNA OUT] connector on the rear panel of
the unit and the TV's aerial connector with the supplied RF
cable.
D Connect the [L-1 IN/OUT] connector on the rear panel of the
Mains outlet
unit and the TV's 21-pin SCART connector with a supplied 21-
pin SCART cable.
●
The [L-1 IN/OUT] connector accepts and delivers either a
composite signal (regular video signal), Y/C signal or RGB
signal.
●
Set your TV to the VIDEO, Y/C, or RGB mode according to the
type of your TV's SCART connector.
8 Component Video Connection
To connect to TV's component video input connectors ^
A Perform steps A - C of ABasic ConnectionB.
B Connect the unit's [COMPONENT VIDEO OUT (Y/P
To
connectors to the TV's component video input connectors.
[AUDIO
OUT] C Connect the unit's [AUDIO OUT] connectors to the TV's AUDIO
input connectors.
●
You can obtain high-quality component video pictures.
●
If your TV is not stereo-capable, use the unit's [AUDIO OUT]
connectors to connect to an audio amplifier for Hi-Fi stereo
Audio cable
sound reproduction.
(not supplied)
●
By using the component video connection, you can view the
images in the progressive mode. For switching to the
progressive mode, refer to AScan Mode SetB (A pg. 64).
NOTE:
Select an appropriate option of AL-1 OUTPUTB as follows
(A pg. 58):
When your TV's SCART
connector accepts:
Composite signals
Y/C signal (separated
luminance (brightness) and
chrominance (colour) signals)
RGB signal
Component video signal
When the setting selected is not in accordance with the TV
connected and depending on the type of appliance connected to
the unit, the correct picture will not appear.
3
Plug the end of the mains power cord into a mains outlet.
●
APLEASEB and AWAITB blink alternately on the front display
panel when the AC plug of the mains power cord is connected
into a mains outlet. And it takes approximately 30 seconds for
the unit to be turned on. This is not a malfunction.
If you possess a satellite receiver, refer to AConnecting To A
Satellite ReceiverB as well. (A pg. 60)

INSTALLING YOUR NEW UNIT

Set AL-1 OUTPUTB to:
ASCART VIDEOB
ASCART S-VIDEOB
ASCART RGBB
ACOMPONENTB
17
EN
/P )]
B R