Table of Contents
Advertisement
110
EN
RECORDING
SYMPTOM
1. The desired programme cannot be
recorded.
2. Recording and editing cannot be
made.
3. Timer programming cannot be made.
4. Timer programming recording does not
start.
5. S
V
Timer Programming cannot
HOW
IEW
be made.
6. Automatic Satellite Programming
recording does not start.
7. On the front display panel, "– –:– –"
appears.
8. "PROGRAM FULL" appears on the TV
screen during timer programming.
9. The disc space does not increase when
recorded programmes are cleared.
INITIALIZING
SYMPTOM
1. Malfunction occurs on the unit.
ATTENTION:
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc,
operate the unit as usual.
POSSIBLE CAUSE
The channel position does not
correspond to that in the receiving area.
No disc or a disc not being compatible
with the unit is loaded.
The disc loaded is not formatted.
A finalised DVD-R disc is loaded.
The disc is full or does not have enough
space for the programme to be recorded.
Date and time is not correct.
Power failure occurred before the timer
programmed recording starts.
Date and time set on the unit is not
correct.
The channel position does not
correspond to that in the receiving area.
The satellite receiver is not connected
properly to this unit.
Power failure occurred.
Eight programmes have already been
timer programmed.
The PC's data recorded on a DVD-RAM
drive cannot be cleared on this unit.
POSSIBLE CAUSE
—
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Set the correct channel position for the
receiving broadcast. (
Load a recordable disc on the unit.
(
pg. 5)
Format the disc. (
pg. 106)
Recording and editing cannot be made on
finalised discs. (
pg. 107) Load a
recordable disc on the unit.
Clear unnecessary programmes on the
disc or load a blank disc. (
Set date and time correctly. (
Check the timer programming. (
Set date and time correctly. (
Set the correct channel position for the
receiving broadcast. (
Connect the satellite receiver to the L-2
IN/DECODER connector properly.
(
pg. 88)
Set date and time correctly. (
Clear unnecessary programmes on the
unit, then try timer programming again.
(
pg. 61)
Format the disc. (When the disc is soiled,
wipe the disc with a soft dry cloth before
formatting.) (
pg. 9, 106)
CORRECTIVE ACTION
Press 1 to turn off the unit, press and
hold 1, then press 8 for two seconds or
more.
pg. 98)
pg. 69)
pg. 104)
pg. 61)
pg. 104)
pg. 98)
pg. 104)
Advertisement
Table of Contents
