•
•
Assembling the MWR Device
Use the following procedure to assemble a MWR Device.
Procedure 2-1 Assembling the MWR Device
Place the brackets at the desired position on the pole.
1
Adjust the position of the box so that the antenna connecters are positioned vertically. Align the antennas
2
with the N-type connectors on the box and rotate to close.
Insert the cable into the external Ethernet port and tighten the connector to ensure a weatherproof seal.
3
Insert the Power Plug into the 4-pin connector.
4
Initial MWR Device Configuration Information
Prior to attempting configuration of a MWR device, the device must be powered up and have
connectivity to the MiSC.
The Geo-location coordinates are entered into an infrastructure device via the Device Manager
Network management tool installed on the MeshManager server (refer to the MeshManager Users
Guide). Motorola recommends that a DGPS receiver be used to obtain accurate GPS coordinates.
Error! Reference source not found. Error! Reference source not found.
The installation location must provide power to the MWR.
It is the responsibility of the Network Operator to ensure that the installation complies
with any local building codes and permits.
MOTOMESH 1.2 Mesh Wireless Router Users Guide
2-5