Kenwood Rapid-Bake BM300 series Instructions/Recipe Book page 63

PROBLEM
15. Kneader cannot
be removed.
16. Bread sticks to pan/
difficult to shake out.
17. Breadmaker not
operating/Kneader not
moving.
18. Ingredients not mixed.
19. Burning odour noted
during operation.
20. Machine unplugged
by mistake or power
lost during use.
How can I save
the bread?.
21. E:01 appears on
display and machine
cannot be turned on.
22. E:02, E:03, E:04, E:05
appear in display and
machine does not
operate.
TROUBLESHOOTING GUIDE (continued)
POSSIBLE CAUSE
PAN PROBLEMS
• You must add water to bread pan and
allow kneader to soak before it can
be removed.
• Can happen over prolonged use.
MACHINE MECHANICS
• Breadmaker not switched on.
• Pan not correctly located.
• Delay timer selected.
• Wholemeal program selected
• Did not start bread maker.
• Forgot to put kneader in pan.
• Ingredients spilled inside oven.
• Pan leaks.
• Exceeding capacity of bread pan.
• If machine is in knead cycle, discard ingredients and start again.
• If machine is in rise cycle, remove dough from bread pan, shape and place in
greased 23 x 12.5cm/9 x 5 in. loaf tin, cover and allow to rise until doubled in size.
Use bake only setting µ or bake in pre-heated conventional oven at
200ºC/400ºF/Gas mark 6 for 30-35 minutes or until golden brown.
• If machine is in bake cycle, use the bake only setting µ or bake in pre-heated
conventional oven at 200ºC/400ºF/Gas mark 6 and remove top rack. Carefully
remove pan from machine and place on bottom rack in oven. Bake until golden brown.
• Oven chamber too hot.
• Bread maker is malfunctioning.
E:02 or E:03 = temperature sensor error
E:04, E:05 or E:08 = heater control
error
SOLUTION
• Follow cleaning instructions after use.
You may need to twist kneader slightly
after soaking to loosen.
• Lightly wipe the inside of bread pan
with vegetable oil.
• Refer to "Service and customer care"
section (page 60).
• Check ON/OFF switch is in the ON
position (see page 4)
• Check the pan is locked in place.
• Breadmaker will not start until the
countdown reaches the program start
time.
• 5-30 minutes delay at start of
program
• After programming control panel, press
start button to turn bread maker on.
• Always make sure kneader is on shaft
in bottom of pan before adding
ingredients.
• Be careful not to spill ingredients when
adding to pan. Ingredients can burn on
heating unit and cause smoke.
• To obtain a replacement, contact
Customer Care on 023 9239 2333.
• Do not use more ingredients than
recommended in recipe and always
measure ingredients accurately.
(see page 4)
• Unplug and allow to cool down for 30
minutes.
• See "Service and Customer care"
section (page 60).
59
, , .