Repair Parts - MasterCraft 55-6896-2 Owner's Manual

Saw vibrates
or shakes.
Laser line
projection is
hard to see.
If the problem remains unsolved after performing the checks described
above, call the Toll-free Helpline, at 1-800-689-9928.

Repair Parts

INCLUDES:
• 1 Pc - 40T carbide-tipped blades
• 1 pc - hold down clamp
• 1 pc - dust collection bag
• 1 pair - extension rails
• 1 pc - wrench
• 1 pc - vacuum adaptor
Saw blade damaged
Saw blade loose
Saw not properly fastened
down
Workpiece not properly
supported
Light in work area is too
bright
Sawdust on the laser lens
Replace blade.
Tighten blade screw.
Fasten saw to stand, bench,
or table.
Properly support or clamp
workpiece.
Move the Mitre Saw to a
work area with proper light.
Clean laser lens using a soft,
dry brush.
25