Maintenance - MasterCraft 55-6896-2 Owner's Manual

CUTTING WARPED MATERIAL (Fig. 14 and 15)
WARNING: In order to avoid kickback and serious personal injury, never
position the concave side of bowed or warped material against the fence.
When cutting warped material, be certain that the material to be cut is positioned
on the mitre table with the convex side against the fence, as shown (Fig. 14).
If the warped material is positioned the wrong way (Fig. 15), it will pinch the
blade near the end of the cut.
Fig. 14
Right
Right

MAINTENANCE

Before cleaning or performing any maintenance, make sure the Mitre Saw
has been disconnected from the power supply. Keep all ventilation openings
clean. Avoid using solvents when cleaning plastic parts. Most plastics are
susceptible to damage from various types of commercial solvents, and may
be damaged by their use. Use a clean cloth to remove dirt, oil and grease.
WARNING: Do not allow improper materials, such as brake fluid, gaso-
line, petroleum-based products, penetrating oil, etc., to come into contact with
plastic parts. These substances contain chemicals that can damage, weaken or
destroy plastic.
WARNING: In order to ensure safety and reliability, all repairs should be
performed by a qualified service technician
Fig. 15
Top View
Top View
Wrong Wrong
Wrong Wrong
23