Assembly; Installing Dust Bag - MasterCraft 55-6896-2 Owner's Manual

18. Spindle-lock button
19. Laser ON/OFF switch
20. Stop latch
21. Bevel-angle scale
22. Bevel lock
23. Bevel-angle indicator
24. Extension wings
25. Hold-down clamp
26. Slide lock
27. Slide rail assembly

ASSEMBLY

INSTALLING A DUST BAG (see Fig. 2)
Make sure the dust-collector bag is
upright (reference the Mastercraft
logo on the bag), and slide the
collar of the dust-collector bag over
the dust-extraction port until it is
attached securely.
Installing the adaptor for a shop
vacuum
Remove the dust-extraction port by
removing the two screws that hold
it in place. Attach the shop vacuum
adaptor using the same two screws.
Releasing and locking the saw head
1. Press the saw head down and
hold it lightly. Pull out the stop
latch in order to release the saw
head. The saw head should move
up and down freely (see Fig. 3).
2. Place the saw head at the lowest
position. Insert the stop latch in
18
Blade Wrench
Saw Blade
Fig. 2
Dust bag
Fig. 3
stop latch
11
23
Dust Bag Shop Vacuum Adaptor
Dust Bag Adaptor
Dust-extrac-
tion port
21
24