Ethernet Connection; Power Supply - Samsung SNB-5000 User Manual

installation & connection
Connecting to the monitor
Connect the video out port of the camera to the video input port of the monitor.
In the initial installation of the camera, you can connect the camera to the monitor for checking
M
the connection status.
You must set <Video output> to <On> before the display screen can be activated. (page 67)
Connect the monitor test cable to the output port of the monitor.

ethernet Connection

Connect the Ethernet cable to the local network or to the Internet.

power Supply

Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
Be careful not to reverse the polarity when you connect the power cable.
J
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
If using PoE, the heater will not operate at all.
Use an adaptor if the installation site requires heater operations. Adaptor is sold separately.
For the power specifications, refer to the "Appendix". (page 94)
The instructions above are also applied to SND-5080/SND-5080F/SNV-5080.
M
0_ installation & connection