Table of Contents
Advertisement
installation & connection
CONNECTING WITH OTHER DEVICE
J
The CVBS out terminal of the product is provided for easier installation, and is not recommended
for monitoring purposes.
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Unit is intended for installation in a Network Environment 0 as defined in IEC TR
62102. As such, associated Ethernet wiring shall be limited to inside the building.
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
If you turn on PoE and DC12V and AC24V at the same time, the first applied one will be used as
the power source.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE802.3af protocols.
Be careful not to reverse the polarity when you connect the power cable.
AC24V can be connected in non-polar union.
If you want to connect an external device, you must turn off the external device before proceeding.
20_ installation & connection
Power
1: GND
4: RS-485 -
2: Tx
5: RS-485 +
7: Alarm in 1
9: Alarm Out
3: Rx
6: EXT D/N
8: Alarm in 2
10: COM
1 2 3 4 5 6 7 8 9 10
FOCUS
ACT
LINK
Ethernet
Grounding
cable
Monitor to install
Advertisement
Table of Contents
