Item
System, Power,
c
SD Indicators
Reset Button
d
Power Port
e
GND
f
Network Port
g
I/O Port
h
Video Out Port
i
ON : While the power is on
POWER
OFF : If the power is off
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Used to plug the power cable.
Used for earth-grounding.
Used to connect a PoE or LAN cable.
ALARM IN
Used to connect the alarm input signal.
ALARM OUT
Used to connect the alarm output signal.
ALARM COM Common port where the alarm output signal is connected.
GND
Used for earth-grounding.
Analog video output port. (for installation)
Description
English _1