Samsung SNB-5000 User Manual page 79

To make recording on the SD memory
1. Check the <Total size> and the <free size>.
2.
If the SD memory has a sufficient free space, set <record> to <on>.
Otherwise, check the stored data and if you find them not important, then click
<format> to format the SD memory.
If your SD memory card writes slowly, only one frame per second will be stored.
For a SD memory card with a large capacity, the formatting will be slowed down accordingly.
Note that only one frame per second (1 fps) will be stored for the following resolutions : 1280x1024,
1280x720, 800x600.
If the size of data grows with time, only 1 fps can be stored even if you set the record quality to Full
Frame.
3.
Specify the record conditions.
Record 1 fps forcibly : Only one frame per second will be recorded regardless of

the existing record profile.
Overwrite : If the SD memory is full, this will delete old data and store new data in

replacement.
Pre-alarm duration : Specify the time point before the occurrence of the alarm;

starting from the time point, the images will be transferred. You can specify up to
5 seconds before the occurrence of the alarm.
Post-alarm duration : Specify the time point after the occurrence of the alarm; to

the specified time point, the images will be transferred. You can specify up to 120
seconds after the occurrence of the alarm.
4. When done, click [Apply ( )].
English _