Cycle Counter; Water Consumption Counter; Remaining Water Quantity Counter For External Water Treatment; Termination Of Setting Mode / Counter Display - Hobart AM900 Installation And Operation Instructions Manual

sEttinGs And countER VAluEs
dE
GB
F
nl
16
10.4

cyclE countER

– Push program button
The display will show alternately "p" or the number of wash cycles.
In the lower display
–
Thousands will be shown in the upper Display
Example: 10 wash cycles
Max. indication: 999 999
10.5

wAtER consuMption countER

Push program button
–
The display will show alternately "E" or the water consumption (liter).
In the lower display
Thousands will be shown in the upper display
Example: 1017 liter
Max. indication: 999 999
10.6 REMAininG wAtER quAntity countER
FoR ExtERnAl wAtER tREAtMEnt
(only available if activated in service mode (s18). the capacity
(liter) of the water treatment has to be stored via c79/80.)
– Push program button
The display will show alternately "d" and/or the remaining water quantity
(liter).
In the lower display
Thousands will be shown in the upper display
Example: 1586 liter
Max. indication: 999 999
To reset the counter to pre-set value, push and hold (3 seconds) the
on/oFF button ➀
10.7

tERMinAtion oF sEttinG ModE / countER displAy

– open the hood and close it again or do not press any button for
10 seconds.
➁ again.
➃ appears the value up to 999.
➄
➁
again.
➃ appears the value up to 999 liter.
➁ again.
➃ appears the value up to 999 liter.
.
.
➄ .
➄ .
AG-1590-A-09-08