Table of Contents
Advertisement
10
Wire the TV-Hub
Follow these steps to wire the TV-Hub.
Antenna
a. Connect the RF1 cable from the antenna to
the "Antenna" jack on the TV-Hub (see
Figure 21).
IMPORTANT!
Do not connect anything other than the
antenna to the "Antenna" jack. The
"Antenna" jack has 42 VDC on it which will
damage other devices such as multiswitches,
DVRs, etc.
b. Hand-tighten the RF cable until it is all the
way into the "Antenna" jack. Then tighten it
with a 7/16" torque wrench to 15 in-lbs, or a
7/16" wrench for 1/8 turn.
The wiring of any additional RF cables in the
configuration is covered in the receiver wiring
section (see
page
13).
Receiver(s)
Connecting the TV-Hub to the system receiver(s),
and setting up the receivers according to the
system configuration depends upon the satellite
television service being used (see Figure 22 and
Figure 23). Detailed instructions are provided in
the next section.
NOTE: The wiring for other optional system
components follows this section. Proper grounding
and power wiring is described in
page
21.
12
"Connect Power" on
Figure 21: TV-Hub Antenna Connection
Deck
10-30VDC IN
Figure 22: TV-Hub A Receiver Connections
TV-Hub A
10-30VDC IN
Figure 23: TV-Hub B Receiver Connections
TV-Hub B
10-30VDC IN
Antenna
RF2 for TV3
dual linear
To antenna only
Hide quick links:
Advertisement
Table of Contents
