10
Wire the Antenna to the TV-Hub
Follow these steps to connect the antenna to the
TV-Hub.
a. Connect the RF1 cable from the antenna to
the "Antenna" jack on the TV-Hub (see
Figure 18).
IMPORTANT!
Do not connect anything other than the
antenna's RF1 cable to the "Antenna" jack.
The "Antenna" jack has 42 VDC on it which
will damage other devices, such as
multiswitches, receivers, DVRs, etc.
b. Hand-tighten the RF cable until it is all the
way into the "Antenna" jack. Then tighten it
with a 7/16" torque wrench set to 15 in-lbs, or
a 7/16" wrench 1/8 turn.
12
Figure 18: TV-Hub Antenna Connection
Deck
To antenna only,
supplies 42 VDC
Antenna