Table of Contents
Advertisement
B
Connecting IP AutoSwitches
Follow the steps below to add IP AutoSwitches
(KVH part no. 72-0634) to DISH Network, Bell
TV, or linear configurations.
Inspect Parts
Follow these steps to inspect the kit contents.
a. Unpack the box and ensure it contains one
each of the following items:
• 3 ft (1 m) Ethernet cable
• 2 ft (60 cm) RF cable
• Adhesive-backed Velcro strip
b. Carefully examine all of the supplied parts to
ensure nothing was damaged in shipment.
c. Locate the serial number on the bottom of the
IP AutoSwitch (see Figure 50) and record it in
the space below. You will need this number
later.
S/N ___________________________________
NOTE: Record all IP AutoSwitch serial numbers
on the Installation Checklist supplied in the
Welcome Kit.
Choose a Mounting Location
Choose a mounting location that meets the
following requirements:
• Dry, well-ventilated, and away from heat
sources
• Provides a clear view of and easy access to
the Master Select button (see Figure 50)
• Provides adequate clearance for running the
cables and allows for service loops and strain
relief
• Within 2 ft (60 cm) of the associated receiver
in order to use the supplied cable
• Either a horizontal or vertical surface
Figure 49: IP AutoSwitch
Figure 50: Serial Number and Master Select Button
Serial Number
Bottom View
Master Select Button
35
Hide quick links:
Advertisement
Table of Contents
