Using System-Related Commands - Fluke 8845A Programmer's Manual

Query SAMP:COUN?
SAMP:COUN? MIN
SAMP:COUN? MAX
TRIGger:COUNt <n>
Description Sets the number of triggers the Meter will take before switching to an idle
state. This setting is stored in volatile memory.
Parameters <n>
Examples TRIG:COUN 430
Query TRIG:COUN?
TRIG:COUN? MIN
TRIG:COUN? MAX

Using System-Related Commands

FETCh[1/2]?
Description Moves measurements stored in the Meter's internal memory to the output
buffer. FETCh1? or FETCh? returns measurements from the primary
display. FETCh2? Returns readings from the secondary display.
Example FETCh2?
DISPlay <n>
Description Enables or disables the Meter's display. This setting is stored in volatile
memory.
Parameters <n>
Examples DISP ON
Query DISP?
Retrieves the number of samples per trigger
presently set in the Meter.
Returns 1 to indicate the minimum number of
samples the Meter will accept per trigger.
Returns 50,000 to indicate the maximum number
of measuremens the Meter will accept per
trigger.
= 0 to 50,000 Number of triggers before Meter becomes
idle.
MINimum Number of triggers is set to 1.
MAXimum Number of triggers is set to 50,000.
INFinite Continuously accepts triggers. A device clear
is required to set the Meter to idle state after
INFinite has been set.
Number of triggers set to 430.
Retrieves the number of triggers presently set in
the Meter. Returns 9.90000000E+37 if trigger
count has been set to INFinite.
Returns 1 to indicate the minimum number of
triggers the Meter will accept per trigger.
Returns 50,000 to indicate the maximum number
of triggers the Meter will accept per trigger.
Retrieves a single measurement from the Meter's
internal memory that was taken by the secondary
display. If secondary measurements are enabled.
= ON or 1 Enables display.
OFF or 0 Disables display.
Enables the Meter's display.
Retrieves the state of the display ( 0 = OFF and 1
= ON).
Digital Multimeter
Supported SCPI Commands
57