Fluke 8845A Programmer's Manual page 61

CALCulate:LIMit:LOWer(?) {<value >|MINimum|MAXimum}
Description Sets the lower limit value used for limit testing. This setting is stored in
volatile memory.
Parameters <value> = 0 to 120 % of highest range.
Examples CALC:LIM:LOW 235
Query CALC: LIM:LOW?
CALC:LIM:LOW? MIN Returns -120 % of highest range of selected
CALC:LIM:LOW? MAX Returns 120 % of highest range of selected
CALCulate:LIMit:UPPer {<value >|MINimum|MAXimum}
Description Sets the upper limit value used for limit testing. This setting is stored in
volatile memory.
Parameters <value> = 0 to 120 % of highest range.
Examples CALC:LIM:UPP -150
Query CALC:LIM:UPP?
CALC:LIM:UPP? MIN Returns -120 % of highest range of selected
CALC:LIM:UPP? MAX Returns 120 % of highest range of selected
DATA:FEED RDG_STORE, <n>
Description Enables (default) or disables storing measurements in the Meter's internal
memory when an INITiate command is executed. When enabled, 5,000
measurements are stored in the Meter's internal memory when executing
an INITiate command.
The MEASure? and CONFigure commands automatically
enable the storing of measurements.
Disabling the storage of readings may be beneficial when performing
statistics operations. Minimum, maximum, and average values can be
calculated without storing each measurement.
While readings are disabled, attempting to transfer readings to
the output buffer with a FETCh? command will generate an
error.
MINimum Sets lower limit register to -120 % of highest
range of selected function.
MAXimum Sets lower limit register to 120 % of highest
range of selected function.
Sets lower limit register to 235.
Retrieves the lower limit register value.
function.
function.
MINimum Sets upper limit register to -120 % of highest
range of selected function.
MAXimum Sets upper limit register to 120 % of highest
range of selected function.
Sets upper limit register to -150.
Retrieves the upper limit register value.
function.
function.
Note
Note
Digital Multimeter
Supported SCPI Commands
53