Prestige Terminal Block Wiring Tool Instructions - Prestige Solo 110 Installation And Maintenance Manual

Prestige Terminal Block Wiring Tool Instructions

Fig. 26: Prestige Terminal Block & Wiring
Tool
WARNING
ELECTRICAL SHOCK HAZARD. For
your safety, disconnect electrical power
supply to the unit before servicing or
making any electrical connections to
avoid possible electrical shock hazard.
Failure to do so can cause severe person-
al injury or death.
NOTICE
Refer to the factory wiring diagram Fig.
17, page 30. Prestige Installation Manual
for proper terminal slot connection.
Wiring Tool Instructions
1. Locate the Wiring Tool on the PRESTIGE
just below the the MCBA control in a plas-
tic bag.
2. Locate the terminal blocks on the PRES-
TIGE below the MCBA control.
NOTICE
The 120V Terminals are located on the
left set of Terminal Blocks. The 24V
Terminals are located on the right set of
terminal blocks.
3. Carefully pull down on the lower half of
the terminal block to remove.
4. Hook wiring tool into the desired slot of the
terminal block as shown in Fig.26.
5. Push wiring tool in towards the terminal
block and insert wire in slot at bottom of
terminal block.
6. Repeat steps 4 & 5 until all wiring is com-
plete.
7. Re-connect the lower half of the terminal
block to the upper half.
8. Place the Wiring Tool back into the plastic
bag or leave tool hooked to a slot on the
24V terminal block.
65