Sections Xiii - Maintenance Schedule; Service Technician - General; Owner Maintenance - Prestige Solo 110 Installation And Maintenance Manual

Maintenance Schedule
SECTION XIII - Maintenance Schedule
Service Technician
At least on an annual basis the following main-
tenance should be performed by a qualified ser-
vice technician:
General
- Attend to any reported problems.
- Inspect the interior of the boiler jacket area;
clean and vacuum if necessary.
- Clean the condensate trap and fill with
fresh water.
- Check for leaks: water, gas, flue and con-
densate.
- Verify flue vent piping and air inlet piping
are in good condition and sealed tight.
- Check boiler water pressure, piping and
expansion tank.
- Check control settings.
- Check ignition electrode (sand off any
white oxide; clean and reposition).
- Check ignition wiring and ground wiring.
- Check all control wiring and connections.
- Check burner flame pattern (stable and uni-
form) and flame.
Additional items if combustion or performance
is poor:
- Clean heat exchanger and flue ways.
- Remove burner assembly and clean burner
head using compressed air only.
Once the maintenance items are completed,
review the service with the owner.

Owner Maintenance

Periodically:
- Check the area around the unit.
- Check and remove any blockage from the
combustion air inlet and ventilation open-
ings.
- Check the temperature/pressure gauge.
Monthly:
- Check vent piping.
- Check combustion air inlet piping.
- Check the pressure relief valve.
- Check the condensate drain system.
Every 6 months:
- Check boiler piping and gas supply piping
for corrosion or potential signs of leakage.
- Operate the pressure relief valve.
WARNING
Follow the maintenance pro c e d u re s
given throughout this manual. Failure
to perform the service and maintenance
or follow the directions in this manual
could result in damage to the PRES-
TIGE or in system components, result-
ing in severe personal injury, death or
substantial property damage.
49