Table of Contents
Advertisement
12 Ending Dr. PICZA
Crick the
button.
13 Items that may not be copied
Unauthorized reproduction of a copyrighted item for any purpose other than personal use may be a violation of copyright. Roland DG
Corp. will not be responsible for any violation of third-party copyright by any article made through use of this product.
14 What to do if...
If you want to completely stop the operation of the PIX-30, detach the AC adapter from AC outlet.
The PIX-30 doesn't operate
Check the following.
- Is the STANDBY key on (with the STANDBY LED lit
up)?
- Are the settings for the computer and software correct?
- Are the cable connected correctly?
- Have the retaining screws and the retainer for the table
been removed? (Refer to "3 Setting up and connec-
tion".)
The STANDBY LEDs repeatedly flashes once
This indicates a communications error.
Switch off the power and check the following.
- Are the communications port settings made for Dr.
PICZA correct?
- Are the connections for the AC adapter and the cable
connecting the unit to the computer secure?
- Are the AC adapter and the cable connecting the unit to
the computer free of any internal broken wires?
- Is the operation of the computer correct?
- Was the power to the computer switched on before the
PIX-30 was turned on?
Be sure to power up the computer first, then switch on
the power to the PIX-30.
- Was the computer restarted?
When the computer has been restarted, switch the
power to the PIX-30 off, wait a few seconds, then
switch it back on.
The STANDBY LEDs repeatedly flashes twice
Something touched the sensor during initial operation
immediately after switching on the power, or a hardware
error occurred.
If there is an obstruction, then switch off the power, remove
the obstruction, and switch the power back on.
If there was a hardware error, then switch the power off and
back on and repeat the same operation.
If the same error display occurs, consult your authorized
Roland dealer or service center.
Pressing the STANDBY key does not switch off the
power.
Unplug the AC adapter from the unit.
The tip of the sensor was inadvertently bent
Please contact your authorized Roland DG Corp. dealer or
service center.
29
Advertisement
Table of Contents
