Roland Picza PIX-30 User Manual page 15

For IBM PC or PC compatible
Serial connector
Use a commercially available Phillips screwdriver to
tighten the screws at either end of the serial cable.
• During scanning, the table moves forward and backward. If the mounted scan object (the three-dimensional object to be scanned) is
larger than the table size, it may extend beyond the front and rear of the unit. Do not place any objects in the area.
• For the cable, use a commercially available crossover serial cable (RS-232C rating). A straight serial cable such as is commonly used
to connect a modem cannot be used. For more on how to connect a serial cable for Macintosh, see "15 Specifications -- Serial Cable
for Macintosh."
• Make sure the power to the computer and the PIX-30 is switched off before attempting to connect the cables.
Freeing the table
Pad
Retainer
Screw
Screw
Crossover serial
cable
AC adapter jack
Screws
Screw
Serial connector
1
Before using the unit, remove the screws and the retainer
shown in the figure.
The table does not move if it remains secured in place by
the retainer. There are screws at two places at the front
and rear.
2
Remove the pad.
* The screws, retainer, and pad are necessary when
repacking the unit. Do not discard them.
For Macintosh
Printer port
Modem port
Connect to either port.
Crossover
serial cable
(for Macintosh)
Included AC adapter
13