Table of Contents
Advertisement
Securing in place with adhesive sheet
1
Peel off the backing paper from both sides of the adhesive sheet, and affix the sheet to the table or a spacer.
* Do not discard the backing paper. It is needed for storing the adhesive sheet after use.
* If necessary, you can also cut the sheet to match the size of the scan object and spacers.
* There is no need to use an adhesive sheet to between spacers or between the table and a spacer.
Adhesive sheet
Peel off the backing paper.
2
Place the scan object on the adhesive sheet, and gently press it down to secure it in place.
When an adhesive sheet is applied to the table and a highly smooth surface of the scan object is stuck on the sheet, it
may sometimes be difficult to peel off the object.
To secure in place, use clay or cut small pieces of adhesive sheet (about 1 cm (3/8 in.) square), and affix them to the
four corners of the bottom surface of the scan object.
Table
22
Scan object
Adhesive sheet
Table
Bottom surface of the scan object
Adhesive sheet
Table
Scan object
Table
Adhesive sheet
No Good
Advertisement
Table of Contents
