Factory Reset; Wireless Detector Settings - Honeywell FMC2000 User Manual

Press Enter. The display shows the message, "Confirm?"
Then do one of the following:
• Press Enter to confirm and restore the configuration.
• Press the left arrow to exit.
• Press the right arrow to go back.

14.11 Factory Reset

This performs a factory reset, which restores all settings in the
FMC2000 to the original settings from the factory. If a factory
reset is performed, then all settings you may have programmed are
wiped clean and overwritten.
A Factory Reset cannot be undone.
Press Enter. The display shows the message, "Confirm?"
Then do one of the following:
• Press Enter to confirm and perform the Factory Reset.
• Press the left arrow to exit.
• Press the right arrow to go back.

15 Wireless Detector Settings

Some settings in the FMC2000 can be selected or written, while
others can only be read. This table explains the three letters that
are shown before each parameter to indicate whether they can be
selected, saved, or only read:
Initial
FMC2000 User's Guide
CAUTION!
Details
Select from a list
Read-only (cannot be changed)
Writable parameter
49