Avaya 1600 Series Installation And Maintenance Manual page 69

4. When control is passed to the software that was just loaded, the following messages
display:
Starting...
Updating boot code...
DO NOT UNPLUG THE PHONE!
This message continues while the new boot code is being written into RAM.
5. The telephone displays the speed of the Ethernet interface in Mbps, that is, 0, 10, or 100.
The message No Ethernet displays until the software determines whether the interface is
10 Mbps or 100 Mbps.
Note:
The Ethernet speed indicated is the LAN interface speed for both the telephone
Note:
and any attached PC, assuming the administrator has not disabled the latter
interface through the PHY2STAT setting.
6. The software determines whether sufficient IP address information was downloaded. In this
scenario, it is discovered that sufficient information has not been downloaded. The
following message displays while the DHCP process is invoked:
DHCP: 0 secs
* to program
The number of elapsed seconds is incremented once per second, until DHCP successfully
completes.
7. While the IP telephone establishes a TCP connection to the HTTP server, the telephone
displays the following message:
HTTP:n ipadd
where n is the number of the IP address obtained from the HTTP server and ipadd is the IP
address.
8. The following message displays while the HTTP process is invoked:
HTTP: n uri
The number increments once per second, until the HTTP server responds.
Scenarios for the Restart Process
Issue 1 April 2007 69