Table Of Zones; Shutdown Diagnostics; To Perform Shutdown Diagnostics - Viper 5900 Installation Manual

table of zones

When using the Diagnostic functions, use the Table of Zones to see which input has triggered the system. It is
also helpful in deciding which input to use when connecting optional sensors and switches.
ZONE NO. TRIGGER TYPE
1 Trunk Input
2 Multiplexed Shock Sensor Input Mux BLUE wire.
3 Door Trigger
4 Multiplexed Shock Sensor Input Mux GREEN wire
5 Ignition
6 Hood Brake Trigger
NOTE: The Warn Away® response does not report on the LED.

shutdown diagnostics

to perform shutdown diagnostics

1. With the ignition OFF, press and HOLD the Valet/Program switch.
2. Turn the ignition ON and then back OFF while HOLDING the Valet/Program switch.
3. Release the Valet/Program switch.
4. Press and release the Valet/Program switch. The LED will report the last shutdown for one minute or until
the ignition is turned on.
LED FLASHES
One
Two
Three
Four
Six
Seven
Eight
© 2006 Directed Electronics—all rights reserved
INPUT DESCRIPTION
BLUE (H1/7)
GREEN (H1/8) and VIOLET (H1/6).
Yellow ribbon harness wire
GRAY on the 6-pin shutdown harness.
SHUTDOWN MODE
Timed out
Over-rev shutdown
Low or no RPM
Transmitter shutdown (or optional push-button)
(-) Shutdown (H3/4 GRAY) or (+) Shutdown (H3/3 BROWN)
(-) Neutral safety shutdown (H3/1 BLACK/WHITE)
Wait-to-start timed out
53