Table of Contents
Advertisement
When using the diagnostic functions, use the Table of Zones to see what input has triggered the system. It is also helpful
in deciding what input to use when connecting optional sensors and switches.
Zone #
Trigger Type
One
Instant
Two
Multiplex
Three
Two-stage, progresses from
warning to full alarm
Four
Multiplex
Five
Two-stage (similar to doors)
The Warn Away
To install the optional VRS
location and plug it into the red VRS
switch must be placed where it can be reached from the driver's seat. Make sure that the customer is aware of the
location of the button and is familiar with the VRS
become stranded by the VRS
IMPORTANT: If the VRS
Learn Routine™ section on page 18.
A few minutes are required to test the VRS
Open the Owner's Guide to Vehicle Recovery System
in detail.
Press and release the VRS
Turn on the ignition and close all the doors.
Wait 15 seconds. The Status LED will begin flashing. This will be followed by chirps and flashing lights,
then by constant siren, in timed progressions described in the Owner's Guide.
The starter kill will be turned on via the orange wire: A) if the ignition is turned off after the chirps have
stopped; or B) as soon as the siren progresses to constant output.
IMPORTANT!: You must make sure that all users of the vehicle know how to disarm the VRS
Remember that the remote does not affect the VRS
standard triggered response from that of the VRS
© 1995,1997 Directed Electronics, Inc. Vista, CA
TABLE OF ZONES
®
response does not report on the LED.
VEHICLE RECOVERY SYSTEM
®
feature, the 8618 starter kill relay must be installed. Mount the button in a well-hidden
®
port on the control unit. Make sure it cannot be pressed accidentally. The
®
®
.
®
button is being installed, you must enable the VRS
®
. To test:
®
push-button switch, with a door open.
Input Description
H1/6 BLUE wire. Connect to optional
Hood/trunk pins
BLUE wire of plug-in shock sensor. Inputs
shorter than .8 seconds will trigger a Warn
®
Away
response, while inputs longer than .8
seconds will instantly trigger full alarm
sequence.
Door switch circuit. H1/5 GREEN or H1/7
VIOLET.
GREEN wire of plug-in shock sensor. Inputs
shorter than .8 seconds will trigger a Warn
®
Away
response, while inputs longer than .8
seconds will instantly trigger full alarm
sequence.
Ignition. H1/9 YELLOW.
®
INSTALLATION
triggered sequence. This will ensure that the customer does not
®
section. The triggered sequence is described
®
, so make sure the user can distinguish the
®
.
22
®
. Refer to Operation Settings
97N437.597
®
.
Hide quick links:
Advertisement
Table of Contents
