Arm/Disarm Diagnostics; System Status Chirps; Table Of Zones - Viper 790XV Installation Manual

Timer Mode
Timer Mode allows the operator to program the remote start system to start the engine every three
hours a total of 6 times. For a full description of Timer Mode activation refer to the owner's manual.
Diagnostics
The system's microprocessor monitors and reports all active and violated zones when arming and
disarming. LED flashes indicate the active or violated zone; siren chirps indicate system status.

Arm/Disarm Diagnostics

The number of siren chirps will indicate the status of the system when arming and disarming. For
information on which zone is active or has been violated refer to the Table of Zones.

System Status Chirps

Action Number of Chirps
Arm 1
Arm 1 (3 second delay), 1
Disarm 2
Disarm 4
Disarm 5

Table of Zones

Zone No. Trigger type
1 Trunk
2 Shock Harness
3 Door Trigger
4 Shock Harness
5 Ignition
6 Hood
NOTE: The Warn Away® response does not report on the LED, but will report on the LCD of the
transmitter/receiver.
36
Description
System armed
System armed with Bypass Notification
System disarmed
System disarmed with Tamper Alert
System disarmed NPC® active
Input description
(-) Input BLUE Multiplex Trigger (H1/6)
BLUE (-) Mux Sensor 1
GREEN (H1/5) and VIOLET (H1/7)
GREEN (-) Mux Sensor 2
YELLOW Ribbon Wire Harness or
PINK Heavy Gauge Relay Satellite Harness
(-) GREY (H3/3) Instant Trigger
© 2002
Directed Electronics, Inc.