Ricoh D158 Service Manual page 904

Bit Switches - 1
No Function
Addition of image data from
confidential transmissions on
0
the transmission result report
0: Disabled 1: Enabled
Print timing of communication
reports on the Journal when no
image data was exchanged.
1
0: After DCS/NSS
communication (default),
1: After polling
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on the
3 error report
0: No 1: Yes
4 Not used
Power failure report
5 0: Disabled
1: Enabled (default)
Conditions for printing the
protocol dump list
6 0: Print for all communications
1: Print only when there is a
communication error
D702
System Switch 09 (SP No. 1-101-010)
If this feature is enabled, the top half of the first
page of confidential messages will be printed
on transmission result reports.
0: The Journal is printed only when image data
is sent.
1: The Journal is printed when any data is
sent.
0: Error reports will not be printed.
1: Error reports will be printed automatically
after failed communications.
1: Error codes are printed on the error reports.
This can be used for detecting an error which
occurs rarely.
Do not change this setting.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when
the power was turned off last.
This switch becomes effective only when
system switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications
with errors.
Comments

If "0" is selected, no reports are
printed and no one may recognize
that fax data is gone due to a power
failure.

The memory size is limited. Use this
bit switch only when some log reports
are necessary.
62 SM