Computer Source Selection - Zenith H27H49S Installation Manual

Computer Source Selection

Choosing the computer input on the Source menus
SOURCE MENU
ANTENNA/CABLE
AUX VIDEO
S-VIDEO
FRONT COMPUTER SVGA
REAR COMPUTER SVGA
COMPONENT YPrPb
PRESS
PRESS OR
ENTER
Selecting Viewing Sources Using
the Onscreen Menus
Selecting Computer Source with Direct
Connection - Auto Source Sensing.
Plug the computer display
15-pin output into the front
Computer In port.
Source Selection Using Remote Control
A
Press TV/VCR SOURCE repeated-
ly on the remote to cycle
through the available sources.
Source Selection Using Source Menu
1
Press MENU repeatedly on the
remote until the Source menu
appears.
2
Use the Up/Down arrow on the
remote control, to select the
computer source that you want
to appear on your screen.
3
Press Enter, or the Left/Right
arrow on the remote, to
change to the new source.
Press ENTER again to remove
menu.
The front panel 'Computer In' port is
auto sensing and must be enabled in
the Installer menu before it will appear
in the Source menu. See Installer menu
item 41-I Auto Compport.
Page 12
TO CHANGE
< >
KEYS TO ACTIV.
SOURCE
FRONT COMPUTER SVGA
PRESS:
SOURCE TO CHANGE
ENTER TO ACTIVATE
Selecting Viewing Sources Using
TV/VCR Source Key on Remote
PRG
CABLE VCR
AUDIO
CHANNEL
VOLUME
CHANNEL
1
4
7
0
1
MENU
2
PAUSE
RECORD
REWIND
POWER
AUX TV
FLASHBK MUTE
VOLUME
2 3
5 6
8 9
ENTER
TV/VCR
TIMER
SOURCE
PLAY
FFWD
STOP
3
3
A