Picture/Sound Source Selection - Zenith H27F56DT Installation And Operating Manual

Picture/Sound Source Selection

Note: The Installer, by changing options in the service menu, can change the default setup and
determine what source connections are available.
• Auto Source Sense connections, front video inputs Camport and S-Video (Y-C), override all other
source inputs. The Auto Sense feature is factory preset to be on; for both front video inputs.
• The Source menu shows what picture and sound sources are available.
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr
Pb
Cable R Audio L
Y
Video In
R Audio In L
M.P.I.
S-Video Out
S-Video In
R Audio In L
Front/Rear
Connection Panels
1
Hook up a device to front Video/Audio In, to use this Auto
Sense source, disconnect when finished.
2
To access other available sources, use the Source menu or use
Channel Up/Down to select AUX input.
Note: The rear Video/Audio In jacks can also be selected by
keying in 999 on the remote number keypad.
Auto Sense source connections override all other sources. The front
Video and S-Video In jacks are Auto Sense source connections. If you
have devices connected to these jacks, you will not be able to change
channels using the TV tuner until you have disconnected those devices.
P A G E 2 0
Camcorder
VCR
S-Video
DVD
Audio/Video
Component Video
Typical Accessory
Equipment
Connectable Sources
See pages 9-17
Antenna/Cable
Camport (Front Video input)
Front S-Video
Aux Video (Rear Video inputs)
Rear S-Video
Component Video
206-3740