Zenith H27H49S Installation Manual page 59

LT2002 QuickSet II Clone Programmer
Cloning Operation Notes
Disconnect the Clone from the TV when you are
finished; automatically switching it Off. The real-
time clock continues to run after the main circuits
have been switched off.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the pro-
grammer behaves strangely after a static shock,
use a paper clip or similar instrument inserted
through the small hole marked "RESET" to activate
the internal reset switch and restore normal opera-
tion.
After a reset, check the real-time clock setting. It
may be necessary to reset the Clone Programmer
clock from a TV containing the correct time.
Clone Programmer/Cloning Procedure Troubleshooting
Problem
Clone Programmer
LED does not blink.
LED slowly blinks green.
LED glows Red.
Clone menu hard
to read.
No time set.
Does not work.
Master and Other TVs
Cloning did not work.
Clone time disappeared.
New Setup not present.
When cloning operations are complete, just unplug the LT2002 from the TV.
If the TV does not display a picture (blank screen) after a few seconds, just change channels.
Possible Cause(s)
• M.P.I. cord not connected.
• TV not turned On.
• Weak batteries.
• Communication problem.
• Batteries are low.
• Weak signal.
• No time on Master TV.
• Digital channel tuned in.
• Procedure interrupted.
• Different TV models.
• Batteries were removed.
• TV not reset.
The LT2002 programmer is designed to be used
with TVs containing the 221-01006 and later
processors. Use with earlier TV sets may give
unpredictable results. The specific microprocessor
used in any TV set may be determined by activat-
ing the Installer Menu. The microprocessor part
number appears on the screen when the Installer
Menu is activated. Processors before the 221-
01006-04 have a limited screen display capability.
They can not display entire screens as shown in
the quick setup instructions accompanying the
LT2002 clone programmer. Use the printed menu
illustrations on the quick setup sheet supplied with
the Clone as an aid in making your programming
choices. (Although the menus are not all dis-
played, the clone functions all operate normally).
Possible Solution(s)
-Connect M.P.I. cord.
-TV must be On for clone to work.
-Install 4 fresh AA high-quality alkaline
batteries.
-Check connections.
-Replace batteries in clone programmer.
-Connect TV to a reliable analog channel
signal source.
-Set time on master TV, copy time to
Clone Programmer.
-Tune to an Analog channel for cloning.
-Wait until procedure complete message
is displayed.
-Cloning is only possible with identical
model Zenith TVs.
-Batteries must remain installed to retain
time settings.
-Disconnect newly-cloned TV from power
for 5 seconds.
Page 59