Using recovery mode
Upgrading software image
To restore a working software image from the Recovery Options page
proceed as follows:
Procedure 8-17 Upgrade software image when in recovery mode
1
Select Browse.
2
Navigate to the required software image. This may be the most recent image
if software corruption is suspected, or an older image if an incorrect image
has just been loaded. Click on the image and select OK.
3
Select Upgrade Software Image. The Upgrade Progress Tracker page is
displayed.
4
When the Software Upgrade Complete page is displayed, check that the
correct image has been downloaded.
5
Select Reboot Wireless Unit. When the 'Are you sure?' pop up box is
displayed, select OK.
6
The unit will now reboot. The unit should restart in normal operational mode
and the link should recover. If the unit or link fails to recover, refer to
link end hardware
8-24
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
on page 8-2.
Chapter 8 Troubleshooting
(Figure
8-8),
Test
phn-0896_012v000
Jul 2010