Task 16: Configure Remote Access; Configuring Http, Telnet And Tftp Access; Figure 6-61 Web-Based Management Page - Motorola PTP 600 series User Manual

Task 16: Configure remote access

Task 16: Configure remote access
This task consists of the following procedure:
•

Configuring HTTP, Telnet and TFTP access

Configuring HTTP, Telnet and TFTP access
The HTTP and Telnet interfaces should be disabled if the HTTPS interface is
configured. See
CAUTION
will be necessary to use the Recovery image to reset IP & Ethernet
Configuration back to factory defaults to re-enable the interfaces.
To configure HTTP, Telnet and TFTP access, proceed as follows:
Procedure 6-46 Configure HTTP, Telnet and TFTP access
1
Select menu option Management, Web. The Web-Based Management page
is displayed
2
Update the attributes as required
3 Select Submit Updated Configuration.

Figure 6-61 Web-Based Management page

6-110
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Configuring HTTPS/TLS
If the HTTP, HTTPS, Telnet and SNMP interfaces are all disabled, then it
(Figure 6-61).
Chapter 6 Configuration and alignment
on page 6-110
page 6-24.
(Table 6-25).
phn-0896_012v000
Jul 2010