User Guide: PTP 600 Series
Step 5: Enter the wireless link encryption key
The wireless link encryption key is used to encrypt all traffic over the PTP600 wireless
link.
NOTE
To enter the wireless link encryption key via the Security Wizard, proceed as follows:
Procedure 6-18 Enter wireless link encryption key
1
The Step 5: Enter The Wireless Link Encryption Key page is displayed
(Figure
2
Select the applicable value in the Encryption Algorithm field.
3
If a valid encryption key exists, then an SHA-1 thumbprint of the key is
displayed. If this key is correct, then take no action. Otherwise, enter the
generated key in the Wireless Link Encryption Key and Confirm Wireless
Link Encryption Key fields. If the two values are not identical, an error
message is displayed.
4
Select Next.
Figure 6-23 Step 5: Enter The Wireless Link Encryption Key page
phn-0896_012v000
Jul 2010
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
If the unit is required to operate in FIPS 140-2 secure mode, Encryption
Algorithm and Encryption Key must be entered.
6-23).
Task 4: Configure security
6-31