System Battery; Replacing The System Battery - Dell Precision Rack 7910 Owner's Manual

System battery

Replacing the system battery

1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the cooling shroud.
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. See your
safety information for additional information.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Locate the battery socket.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector
while installing or removing a battery.
2. Place your finger between the securing tabs at the negative side of the battery connector and lift the
battery out of the socket.
Figure 41. Removing the system battery
1. positive side of the battery connector
2. system battery
3. negative side of the battery connector
3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing
tabs.
Safety instructions.
Before working inside your system.
85