Table of Contents
Advertisement
Figure 49. Installing the D12 PSU
3. Bundle the PSU cable with equal interval spaces between cable tie.
Next steps
1. Connect the power cable and the power dongle cable on the system board connectors.
2. Follow the procedure listed in
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
A new battery can explode if it is installed incorrectly. Replace the battery only with the same
or equivalent type that is recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. For more information, see the Safety instructions documentation that is shipped
with your system.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
58
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
