Ir3 Log Placement - Napoleon XIR3N Installation And Operating Instructions Manual

4.3

IR3 LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
PHAZER TM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the rear log behind the left
and right log supports and ensure
that it's tight to the burner. Make sure
to centre the pilot in the notch. Adjust
the log supports tight to the log to
hold it in an upright position.
D. Position the left charcoal strip in
front of the left middle log, lining up
the holes in the bottom with the 2
front left studs.
G. Position a pin into the right side
hole of the rear log, move the right
crossover log into position, lining
up the top hole with the pin in the
rear log.
DAMAGE OR PERSONAL INJURY.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
LOG SUPPORT
B. Place the left middle log into
position, lining up the two holes in
the bottom with the studs located
on the left side of the burner.
E. Position the right charcoal strip
in front of the right middle log, lining
up the holes in the bottom with the
2 front right studs.
WARNING
!
IGNITION MAY OCCUR.
76.1A
C. Place the right middle log into
position, lining up the two holes in
the bottom with the studs located on
the right side of the burner.
F. Position a pin (supplied) into the
left side hole of the rear log, move
the left crossover log into position,
lining up the top hole with the pin in
the rear log.
W415-1033 / A / 10.12.11
13