Miele CVA 5065 User Manual page 69

. . . the message "Fault - 28" appears
in the display.
Enough ground coffee for one portion,
i.e. a level coffeespoonful of ground
coffee, passes through the ground
coffee chute. If there is too much
ground coffee, the machine is unable to
process it so that it can be emptied into
the waste container, and a fault
message appears in the display.
^ Switch the machine off and then on
again after a short while.
. . . the message "Fault -73" appears
in the display.
The brew unit cannot be positioned
correctly.
^ Take the brew unit out of the machine
and clean it thoroughly (see
"Cleaning and care - Brew unit").
^ Push the coffee ejector of the brew
unit into the correct position.
^ Set the brew unit to one side and
replace the waste container and the
water container in the machine.
^ Close the door.
The brew unit motor will now move
into the correct position.
Problem solving guide
^ When "Fit the brew unit" appears in
the display, open the door and
replace all the parts in the machine.
^ Close the door.
If the fault message continues to
appear in the display, please call the
Miele Service department, quoting the
fault code.
. . . "Fault - 74" or "Fault - 77"
appears in the display?
^ Switch the machine off and then on
again after a short while.
If the Fault message appears in the
display again, contact the Service
department.
. . . the message "Check the brew
unit" appears in the display.
The brew unit may be dirty.
^ Follow the instructions in the display.
^ Clean the brew unit (see "Cleaning
and care - Brew unit").
^ Set a medium grinder setting and a
medium amount of coffee (see
"Setting the coffee grinder" and
"Settings: customising your machine -
Setting the amount of coffee").
Set the grinder setting and the
amount of coffee to medium in any
User profiles as well.
. . . the ground coffee chute cover
cannot be pushed in properly.
^ Is the lid of the ground coffee chute
closed?
69