Miele CVA 5065 User Manual page 68

Problem solving guide
. . . the message "Push water
container in as far as it will go"
appears in the display.
Water has not been taken in.
^ The water container is not correctly
positioned inside the machine. Take
it out and push it back into the
machine so that it clicks into position.
^ This error message also appears if
the water container was not correctly
filled for descaling. Fill the water
container up to the marker.
If this fault message still continues to
appear in the display, repeat the steps
described above. If neither is the case
and the fault message still appears in
the display, call the Miele Service
Department.
. . . the message "Check water inlet"
appears in the display.
There is a problem with the water inlet
for the plumbed in water supply.
^ Check whether the inlet hose has
become kinked or the stopcock is not
fully open.
^ Remove the water container and
empty it.
^ Push the water container back into
the machine so that it clicks into
position.
If a Fault message appears in the
display, contact the Service
department.
68
. . . too much crema has formed and
is overflowing above the coffee
spouts.
Some types of coffee will produce too
much crema if the coffee or espresso
temperature is set to maximum and the
amount of coffee to be ground is set too
high.
^ Set a lower temperature and reduce
the amount of coffee to be ground
(see: "Settings: customising your
machine - Setting the temperature"
and "Setting the amount of coffee").
. . . the slide control for the grinder
setting will not move.
^ Close the machine door and
dispense a cup of espresso coffee.
The grinder setting slide control will
now move.
. . . "Fault - 1" to "Fault - 4" or
"Fault - 80" to "Fault - 83" appears in
the display.
^ Switch off the machine using the
On/Off sensor, and wait for one hour
before switching it on again.
If the Fault message appears in the
display again, contact the Service
department.